Caring For Your Umbrella
Daily Care
Your Umbrella has been designed to be resilient to various weather conditions but can be susceptible to being crushed or bent, so we reccomend that you keep it stored carefully when not in use. Your brolly will be there for you when you need it if you care for it well when you don’t.
Cleaning and Maintenance
Most of our Umbrella canopies are made from a weatherproof material called ‘Pongee’ which is a cotton and linen mix, covered by a protective coating. It will wash effectively with warm soapy water but will discolour if you use many cleaning fluids or strong detergents. A warm soapy wash should be all your brolly needs.ย
Our Umbrella shafts are made from tubular steel, with many of them coated in a protective coating. Again, a warm soapy wash will clean away most dirt.
The ‘Flip’ Umbrellas have dual canopies. They are attached to the chassis at the ends of the ribs by small metal clips. These can be unclipped easily for cleaning and maintenance by simply unclipping the ends with the Umbrella when in the closed position. Opening the Umbrella will then give you easy access to clean the canopies and the ribs. The metal tips can be fragile so we reccomend that you do not force them or apply pressure.ย
Self Repair Guide
ย 
Replacing the Flip Umbrella tips
The Flip Umbrella tips are sewn into the canopy joints and clip together and then onto the end of the ribs to hold the dual canopy ends to the chassis. The tips clip apart for cleaning and maintenance.
If they are bumped hard, the more common of the two tips to break is the mid tip that sits between the end tip and the end of the rib. However, both tips are sewn in the same way.


- Unclip the tips and remove the damaged tip from the canopy by cutting the stitching.
- Remove any excess cotton from the existing stitching of the tip.
- Prepare a needle and a length of black cotton (approx. 25-30cm) and knot the end of the cotton
- Sew in a few stitches to the canopy to secure the cotton.
- Hold the tip in place on the joint of the canopy to the inside side of the canopy with half of the tip overhanging the end of the canopy (see pic above).
- Sew through the eye of the tip and through the joint of the canopy and loop across the front of the tip.
- Keep sewing the same loop until the eye of the tip is packed with cotton and sew a couple of loops into the canopy to secure the cotton.
- Trim the cotton ends to tidy.
- Clip together the tips and open and close the umbrella a few times to test.
ย
Re-bonding the C’Handle to the shaft of the Flip Umbrella
Unfurl the canopy and stand the umbrella on its base with the handle end facing upwards. Check that the red button has clicked into the ‘closed’ catch position so that it can’t go any further down the shaft.
The best glue to use is an Epoxy Resin based glue or similar.
Place a good ring of glue all around the inside of the hole that the shaft will slot into.
Carefully slide the handle onto the end of the shaft with a slight twisting motion to spread the glue as it pushes on.
Leave a gap of about 5mm between the end of the handle and the gripper that houses the red button.
Leave standing to dry and then test.


Umbrella Stands